Silicone Render System installed for one of our commercial Clients.
Project completed in Glasgow Fort Shopping Centre. Large elevation of the River Island shop.
Complicated and detailed job completed to the full satisfaction of the Client (as always! 🙂 )
FEEDBACK / REFERENCES: –->>CLICK HERE<<–
SILICONE RENDER SYSTEM AS FOLLOWS:
-hammer test to find all the hollow/boss areas in existing wall covering
-removing all defective areas
-dubbing out to bring the level up
-proper, deep-penetrating bonding agent
-PVC beads and trims (1st fix)
-base coat adhesive render (modern, strong and specially enhanced/reinforced, breathable render)
-fibreglass mesh properly embedded in the base coat render
-extra mesh to all the corners of all the openings (stress patches)
-system fixings (if required only) (50mm, large, flat-heads, PVC fixings to mechanical tie the base coat and mesh to the substrate)
-PVC beads and trims (2nd fix)
-2nd pass of the base render
-smoothing the surface
-coloured or white, silicone-based, primer
-coloured or white, thin coat (1.5mm grains), silicone-based top-coat render
-texturing
-low modulus, external quality mastic sealants (all around the system)
